HK-5SN carriage's welding position is in the middle of its body.It is used in general welding, especially long horns of the welding.Carriage can weld while walking forward and backward. It is easy to move and install the carriage under different conditions due to its small volume and light weight. Carriage’s movements have high stability because of synchronous four-wheel drive. Start to weld when carriage is set on automatic control. The number of stuff is reduced; a workman can make many dollies to weld at the same time. Workmen those who have not be trained can also weld. Due to equipment’s miniaturization ,little weight and easy automatic operation, a workman without training can do better by it than technical worker using normal welding machine. Equipped with fixator for welding gun, it can weld more stably to improve welding quality. Aluminium extruded sections are assembled in mosaic pattern into baseboards; axles are equipped with extra silicon rubber sealing gaskets; carriage’s internal dustproof effect is very good. Because of the copper gear transmission of the carriage,systems can be prevent from magnetizing efficiently.
Constituent instruction
HK-5SN is made up of carriage body, guide wheel, torch handle, X-Y slide, torch wiggler and control box.
carriage body:It is the frame of machine and carrier of others.
1. Control panel 7.Torch
2. Control box:It can adjust all actions of carriage. Please refer to “explanation of control panel”
3.Walking whell 4. hand grips:Please hold this hand grip when you carry the machine.
4. hand grips:Please hold this hand grip when you carry the machine.
5. X-Y moving slide:Use it to adjust the position of torch. In the process of welding, you can tune the torch up and down
6. Guide pulley bar
7.Torch
8. Welding torch gripper: It is used to fix the torch. You can take down torch by it, when you want to repair or adjust the torch.
9. Base
10. Guide wheel assembly: It rolls along the base metal surface and align the torch to the welding part
11. Insulation baffle board
Main technology parameter
1. size |
282mm×234mm×164mm |
|
2. Weight |
8Kg |
|
3. Power |
AC220V / DC24V |
|
4. power |
22W |
|
5.adsorbability |
10~25Kg |
|
6. walking speed |
150~900mm/min |
|
7. Range of adjusting welding torch |
Up an down |
50mm |
left-right |
50mm |
|
range of working angle |
±45° |
|
range of adjusting angle |
10° |
|
Range of working angle |
360° |
Welding parameter
welding wire diameter welding parameter |
Φ1.2mm |
Φ1.4mm |
Φ1.6mm |
|
current(A) |
Down hand welding |
120-300 |
150-380 |
180-430 |
flush fillet welding |
120-280 |
150-320 |
180-380 |
|
horizontal welding |
120-280 |
150-300 |
180-330 |
|
voltage(U) |
|
|||
distance between nozzle and workpiece(H) |
|
|||
welding extension length(L) |
The length is about 10 times welding wire diameter. It is L=10d |
Contents of package
1. Body |
1set |
2. Regulated power supply DC24V |
1set |
3. Standard power cord 20m |
1set |
4. 2Pcontrol wire of blowtorch 5m |
1set |
5. Fuse 3A |
3set |
6. Specification sheets(M3、M4、M5、M6) |
1 set |
7. certificate of qualification |
1 set |